Transformador de iluminación GET, 230 → 240V ac, 11.4 → 11.6V ac, Electrónico

Código de producto RS: 486-142Marca: GETNúmero de parte de fabricante: GTRE65P

Documentos Técnicos

Especificaciones

Brand

GET

Tensión nominal primaria

230 → 240V ac

Tensión nominal secundaria

11.4 → 11.6V ac

Dimensiones del Cuerpo

124 x 40 x 30 mm

Longitud

124 mm

Ancho

40 mm

Profundidad

30 mm

Requisito de carga mínimo

20W

Peso

107 g

Tipo

Electronic

Atenuación

Dimming

Método de atenuación

Salida

Corriente nominal primaria

5.4

Frecuencia de funcionamiento máxima

50Hz

País de Origen

China

Datos del producto

Low Voltage Lighting Transformers

Dimming Methods (where applicable):
Leading Edge:
The control device is either a thyristor or triac which blocks power until they are switched on by the control signal. At that point the current flows almost instantaneously and continues to flow until the end of the half cycle of the mains waveform. When the signal reaches zero, the device turns off and no more current is passed until it is triggered again. Turning the power on and off in this manner averages out creating a constant intensity level and by altering the precise trigger point over a period of time the lamp can be dimmed.

Trailing Edge:
Since this method of dimming uses transistor technology it is not limited to just switching, therefore current can be controlled gradually. Transistors can be programmed to pass current at the start of each half cycle, and gradually switch off later. This will control the full amount of power reaching the lamp without the side effects of a step increase in current.

Información de stock no disponible temporalmente.

Vuelva a verificar más tarde.

Información de stock no disponible temporalmente.

P.O.A.

Transformador de iluminación GET, 230 → 240V ac, 11.4 → 11.6V ac, Electrónico

P.O.A.

Transformador de iluminación GET, 230 → 240V ac, 11.4 → 11.6V ac, Electrónico
Información de stock no disponible temporalmente.

Documentos Técnicos

Especificaciones

Brand

GET

Tensión nominal primaria

230 → 240V ac

Tensión nominal secundaria

11.4 → 11.6V ac

Dimensiones del Cuerpo

124 x 40 x 30 mm

Longitud

124 mm

Ancho

40 mm

Profundidad

30 mm

Requisito de carga mínimo

20W

Peso

107 g

Tipo

Electronic

Atenuación

Dimming

Método de atenuación

Salida

Corriente nominal primaria

5.4

Frecuencia de funcionamiento máxima

50Hz

País de Origen

China

Datos del producto

Low Voltage Lighting Transformers

Dimming Methods (where applicable):
Leading Edge:
The control device is either a thyristor or triac which blocks power until they are switched on by the control signal. At that point the current flows almost instantaneously and continues to flow until the end of the half cycle of the mains waveform. When the signal reaches zero, the device turns off and no more current is passed until it is triggered again. Turning the power on and off in this manner averages out creating a constant intensity level and by altering the precise trigger point over a period of time the lamp can be dimmed.

Trailing Edge:
Since this method of dimming uses transistor technology it is not limited to just switching, therefore current can be controlled gradually. Transistors can be programmed to pass current at the start of each half cycle, and gradually switch off later. This will control the full amount of power reaching the lamp without the side effects of a step increase in current.